12168823 MAIN printboard CARD TP2 fagor domus primer danube

12168823 MAIN CARD TP2 (LIGHT) 

oud nummer  12120815

We send you the newest print board that comes with a network connection.

If you like too use the network connection you need also a new processor module that is clicked on the mainboard with a software version higher then 2.1

Printboard and Processor module are seperate!

Only with the newest version higher then 2.1 processor module you can arange network connection.

print board voor de Fagor wasmachines alle type LA-LN-LR en LAP

Also for Danube WET washers, Domus washers, Primer washers

printboard is exclusief processor board

Heeft u deurslot problemen vervang dan uw oude print voor de nieuwe print

Deze print is voor FAGOR DANUBE DOMUS PRIMER wasmchines met touchscreen klein 4,3 inch en 7 inch touchscreen. Op de print zit een jumper om het grote van het scherm in te stellen.

alle verwarmingen kunnen worden aangestuurd : eletrisch, stoom, warmwater

De print is geschikt voor coin als opl machines

1 model print voor alle wasmachines hoogcentrifuge, normale centrifuge, medium centrifuge

when changing this printboard becareful of the connection with the display.

There is a little cap on the back of the connection from the flatcable or there are two little caps on each side of the connection.

for the big cap move it a little up en the flatcable can be removed

for the 2 small caps move them outside the board a little and the flatcable can be removed

If your machine have shortcircuit possible cause is water damage on the front of the printboard

processor can be removed by clipping the 2 clips away from the processor.

If you display is lightning up ( backlight) but only give white screen then it is also posible the processor board is freezing. This can happens with software version 2.23 and lower.

The version is written by pen on the module. Starting from 1.7 - 2.1 - 2.23 ......

If there is no backlight on your display check your mainboard on the back. When the mainboard have power there is a green led lightning up. If not check the two fuses at the back of your machine.

Open the plate around the mainswitch and on the most right side there are two fuses inside the brown or grey connections you can clip then open and take them out to replace them.

12168823 MAIN printboard CARD TP2 fagor domus primer danube